If you have two-sided sign, you need to set up another sign for Sign 2įrom the “Sign Setup” window click on “New Sign” buttonĬlick “OK” (this takes you back to sign set up window) Click “OK” (this takes you back to “Sign Setup” window).” Sign Color” is RG Color if you have a tri-color sign or mono for a monochrome sign.” Sign Height ” > this depends on what type of sign you have – check your documentation.” Sign Width” > this depends on what type of sign you have – check your documentation.For “Alias” just leave it blank (optional).Select the “Sign” in the column and click the “Delete Sign” button.Delete all signs on the left hand side and sign types on the right hand side:.If the “Sign Setup” is incorrect then follow the instructions below This is the matrix (height and width of your sign) plus the color of your sign (RG for tri-color sign and RGB or full for full color sign). The “Type” depends on what type of sign you have. Make sure settings on the left hand side of the Sign Setup window are correct – as shown in the example here Go to “Sign Setup” (the “Sign Setup” window appears).On the upper left hand side of the software screen click on “File”.There are the steps to set up the sign to communicate with SignX once again. ![]() In these cases the best course of action is to go through the Sign Setup process again. The SignX software may not have been setup properly initially or it may have gone back to default settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |